Wintriss SmartPAC 2, User Manual

Page: 233 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Initialization Mode 4-47
SECURITY ACCESS
(INITIALIZATION – TOOL INFORMATION)
The SECURITY ACCESS item on the Main Initialization Menu allows you to control user
access to SmartPAC 2 operating modes and settings. You set user access on the Security
Access Menu, which is shown in Figure 4-30.
For most items on the Security Access Menu, you can specify three types of access:
•
PROGRAM AND RUN MODES. Allows users to change settings in both Program and
Run modes. This access type is the least secure.
•
PROGRAM MODE ONLY. Allows users to change settings only in Program mode (i.e.,
when the Program/Run key is in the PROG position). To prevent users from entering
Program mode, you should remove the Program/Run key with the switch set to RUN.
•
PASSWORD REQUIRED. Allows users to change settings only after they have entered a
password. This access type is the most secure.
The following items on the Security Access Menu allow you to select other access options
(see Table 4-15, page 4-48 for a complete list of security access settings):
•
CHANGE COUNT and CHG GOOD PRTS CNT. These items allow you to specify NO
CHANGES ALLOWED, which prevents changes to actual counter values for strokes, good
parts, total hits, and batch counters (CHG COUNT) or for good parts only (CHG GOOD
PRTS CNT). This setting is applicable in either Program or Run mode.
•
INIT. PASSWORD. This item allows you to require a password for user access to the Main
Initialization Menu. To require a password, highlight the MUST BE USED selection.
Otherwise, select NOT REQUIRED.
•
LOAD MONITOR. This item has four options: ALLOW RECALC/ADJUST, ALLOW
RECALC ONLY, NO RECALC/ADJUST, and PASSWORD REQUIRED.
•
CHG TOOL TEMPLATE. This item has two options: PASSWORD REQUIRED and
PASSWORD NOT REQUIRED.
Figure 4-30. Security Access Menu
F1
F2
F3
F4
F5
F6
F7
F8