Wintriss SmartPAC 2, User Manual

Page: 278 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
5-24 Program Mode
This screen allows you to set the Auto Enable by Sensor counter, which specifies the number
of press strokes necessary to re-enable the sensor following a DISABLE SENSORS command
(see
SENSOR ENABLE/DISABLE & STATUS (Optional)
, page 5-52 and
DISABLE (ENABLE)
SENSORS
, page 6-6).
To set the Auto Enable by Sensor counter, do the following:
1.
On the Auto Enable by Sensor Counter screen, select the value in the AUTO ENABLE
COUNTER field. The Numeric Entry window (see Figure 5-3, page 5-3) displays.
2.
Key in the value you want (maximum is 99), following the directions in the window, and
press ENTER. The value you keyed in displays in the AUTO ENABLE COUNTER field.
3.
Press ENTER to display the Sensor Type screen (see next section).
Setting Sensor Type
After you select a sensor name and, if AUTO ENABLE BY SENSOR is the Initialization
setting, specify the Auto Enable stroke count, the Sensor Type screen, shown in Figure 5-25,
displays. The name you selected for the sensor is shown at the right of the Status Box beneath
the sensor number.
You can select one of six types of sensor (see
Sensor Types
, page 5-17 for details), or you can
select NOT USED, in which case that sensor is not programmed for the tool.
To set the sensor type, do the following:
1.
Select the sensor type you want. For all selections except UNUSED, the Sensor Stop Type
screen (see next section) displays with the sensor type you selected displayed at the right
of the Status Box beneath the sensor name.
If you selected UNUSED, you are returned to the Die Protection Sensor Menu. The name
of the sensor you started to program is reset to SENSOR 1, SENSOR 2, etc.
Figure 5-25. Sensor Type Screen