Wintriss SmartPAC 2, User Manual

Page: 366 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
7-4 Fault Messages
When the Stopping Time of the press exceeds the Stop-time Limit, the following message
displays on the SmartPAC 2 LCD
The Stopping Time of the press has
exceeded the Stop Time Limit. Check
the brakes and make sure that the
press is safe to operate.
and WPC 2000 prevents the press from being operated until the brake has been completely
repaired.
To respond to this fault, do the following:
1.
Contact your maintenance crew and have them repair the brake immediately.
2.
When the brake has been repaired, press the RESET key to clear the Stopping Time fault.
3.
When the Lockout message displays (see page 7-3), turn the Stroke Select switch to
“OFF,” then to “INCH” to clear the message.
4.
Run the press several times to determine its Stopping Time, and compare this value to the
result of your last Stop-time tests, referring to the procedure starting on page 6-22.
5.
Determine whether you need to adjust the previous Stop-time Limit, and make
adjustments if necessary.
PRESS MALFUNCTION
Correct or repair any press malfunction or wiring error before restarting the press.
Failure to comply with these instructions will result in death or serious injury.
BRAKE WARNING
The Brake Warning LED alerts you when the Stopping Time of the press is within 10 mS of the
Stop-time Limit.
If you try to run the press without first repairing the brake, WPC 2000 will stop the press on the
next stroke and again display the Stop Time Exceeded fault on the SmartPAC 2 display. The fault
will continue to appear until the brake has been repaired.
DANGER
!
NOTICE
NOTICE