Wintriss SmartPAC 2, User Manual

Page: 368 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
7-6 Fault Messages
The two-digit number following the initial letter identifies the specific WPC 2000 fault. For
example, fault code F53, which is shown in Figure 7-3, indicates a problem with the
equipment connected to User Input 3, the name of which (i.e., “Die Nitrogen”) has been
programmed by the user in SmartPAC 2 Initialization (see
User Interlocks
, page 4-24). Each
of the 7 non-control-reliable user inputs and each pair of the 2 cross-checked control-reliable
inputs is provided with a unique status code. Fault codes also document problems with the
resolver, Dual Safety Valve (DSV), Operator Station, and other WPC 2000 components.
To respond to a fault, do the following:
1.
Correct the problem that caused the fault.
2.
Clear the fault code or message on the SmartPAC 2 display by doing one of the following:
•
To clear F and H faults, press the RESET key on the display or a Remote Reset switch if
one is installed.
•
To clear E faults, power down SmartPAC 2 and WPC 2000, then power the units back
up.
All E, F, and H faults are documented in numerical order in the following sections.
Resolver Faults
Problem
: The press is running faster than 1000 SPM, the resolver has failed, or the wiring in
the resolver circuit to WPC 2000 is loose or bad.
Remedy
: If WPC 2000’s rated press speed is exceeded, reduce the speed. If press speed is
not the problem, check the resolver wiring for shorts, breaks, or loose connections
(see
Wiring the Resolver
, page 2-25). If wiring is not the problem, the resolver is
probably bad and will have to be replaced. If necessary, contact Wintriss Tech.
Support for assistance or replacement of the resolver.
CLEARING “E” FAULT CODES
To clear E fault codes, do the following:
1. Power down SmartPAC 2 and WPC 2000.
2. Power up SmartPAC 2 and WPC 2000.
E06
NOTICE