Wintriss SmartPAC 2, User Manual

Page: 140 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
2-96 Installation
Anti-tiedown Test
The anti-tiedown test verifies that the Operator Station is installed correctly and is wired so
that both hands are needed to press the Run/Inch buttons simultaneously. To perform the test,
do the following:
1.
On the SmartPAC 2 front panel:
•
Turn the Program/Run key switch to RUN.
•
Turn the Stroke Select key switch of OFF.
•
Select TWO HAND on the Mode Select Menu (see page 6-40)
•
Turn the Stroke Select key switch to SINGLE STROKE.
2.
Press and hold down both Run/Inch palm buttons to cycle the press through one stroke.
When the press top-stops, continue to hold down the left button, and remove your hand
from the right button; then, after a moment, replace your hand on the right button and
continue to hold down both buttons.
•
If the press does not initiate the stroke, go to the next step.
•
If the press does initiate the stroke, check the wiring of the palm buttons. When the
problem has been corrected, repeat step 2. If the press still initiates the stroke, call
Wintriss Tech. Support.
3.
Remove both hands from the Run/Inch buttons.
4.
Press and hold down both Run/Inch buttons to cycle the press through one stroke. When
the press top-stops, continue to hold down the right button, and remove your hand from
the left button; then, after a moment, replace your hand on the left button and continue to
hold down both buttons.
• If the press does not initiate the stroke, the test has been completed successfully. Go to
the next applicable test.
INJURY DURING TESTING
• Keep all personnel away from the press during testing.
• Be sure there is no die or other tooling in the press during testing.
Failure to comply with these instructions will result in death or serious injury.
OPERATOR STATION MAY NOT MEET SAFETY REQUIREMENTS
• Ensure that the Operator Station is wired correctly.
• Ensure that on any non-Wintriss Operator Station the Run buttons are placed so that two hands
are required to push both buttons at the same time and no one can press both buttons with one
hand or with one hand and one elbow.
• Ensure that on any non-Wintriss Operator Station the Run buttons have ring guards or other
means in place to prevent unintentional operation.
Failure to comply with these instructions will result in death or serious injury.
DANGER
!
DANGER
!