Wintriss SmartPAC 2, User Manual

Page: 155 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Installation 2-111
Verify that the “S.S. SEL” and “PALM A N/C” items on the WPC Buttons and Switches
Input Status screen are ON (see Figure 4-26, page 4-45).
2.
Make sure that option switch 3 on the WPC 2000 Main Processor board is set to OPEN, its
default setting (see
Enabling Light Curtain Break Mode in a One-hand Control
,
page 4-36).
3.
Power down, then power back up the WPC 2000, if necessary, to enable the settings
change. The WPC 2000 is now in normal One-hand Control operation, the press stroking
each time the One-hand Control switch is depressed.
4.
Press the One-hand Control switch and release it immediately. The press should make a
single stroke and stop at top dead center.
Verify that the “ONE HAND N/O” item on the WPC Buttons and Switches Input Status
screen (see Figure 4-26, page 4-45) changes from an OFF to an ON status when the
One-hand Control is depressed and that the “PALM A N/C” item changes from ON to
OFF.
•
If the press makes a complete stroke and the status of the “ONE HAND N/O” and
“PALM A N/C” inputs is correct, go to the next step.
•
If the press does not make a complete stroke or the status of the inputs is not correct,
check the wiring of the One-hand Control, the setting of switch 3 (it should be OPEN),
and the selection on the Mode Select Menu (ONE HAND should be selected). Make
any necessary corrections, and repeat step 4. If the press still fails to make a complete
stroke or input status is still incorrect, contact Wintriss Tech. Support.
5.
Set option switch 3 to CLOSED.
6.
Power down, then power back up WPC 2000 to enable the settings change. You are now
in Light Curtain Break mode. The press should cycle to Top-stop only if the One-hand
Control is pressed within eight seconds of the operator’s hand clearing the light curtain.
7.
Without breaking the light curtain, press the One-hand Control. The press should not
cycle.
•
If the press does not cycle, go to the next step.
•
If the press cycles, check the wiring of the One-hand Control and the setting of switch 3
(it should be CLOSED). Make any necessary corrections, and repeat step 7. If the press
still cycles, call Wintriss Tech. Support.
Depress the One-hand Control switch quickly and fully to initiate a stroke. If you depress
the One-hand Control switch slowly or partially, the press will not stroke.
If the Interrupted Stroke message displays, you must press and hold the Run/Inch buttons
on the Operator Station to bring the press back to top dead center and clear the
Interrupted Stroke before you can operate the One-hand Control.
NOTICE
NOTICE