Wintriss SmartPAC 2, User Manual

Page: 423 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Preventive Maintenance Monitor C-9
1.
Select “New item” from this display. (You may be asked for a password before getting to
this screen. If so, enter it.)
2.
Next, you will see the following display. You should give the item a name that best
describes its function, so first check the list for a suitable name.
3.
To see the complete list of names, press the “down” cursor key until the bottom name on
the list is highlighted, then keep pressing it. A new name will appear each time you press
the key. You can use the “up” cursor key to reverse direction.
4.
If you do not find a suitable name but you still want to name the item, you can select
“Custom Name” by highlighting it and pressing Enter.
5.
As the screen suggests (see the next illustration), certain keys enable you to custom name
the item. The name you select can be any combination of alphanumeric characters,
Figure C-7. PM Monitor Screen
Figure C-8. List of Available PM Names Screen
ITEM ALERT EVERY
USE THE CURSOR KEYS TO MAKE
SELECTION. PRESS ENTER TO
SELECT, RESET WHEN DONE.
INIT
F6
YOUR PRESS NAME PM MONITOR
NEW ITEM
PM MONITOR
MORE
AIR ROTARY SEALS
BCKSHFT BEARING 1
BCKSHFT BEARING 2
BCKSHFT BEARING 3
BCKSHFT BEARING 4
BRAKE
BULL GEAR
CLUTCH VALVE
CONVEYOR 1
CONVEYOR 2
CONVEYOR 3
CONVEYOR 4
CONVEYOR 5
CONVEYOR 6
USE THE CURSOR KEYS TO
MAKE SELECTION. PRESS
ENTER TO SELECT, RESET
WHEN DONE.
YOUR PRESS NAME
"CUSTOM NAME"