Wintriss SmartPAC 2, User Manual, Page: 194 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
4-8 Initialization Mode
Counter Setup Mode
(INITIALIZATION – POSITION SENSOR)
This item allows you to enable or disable counter setup mode. To set this parameter, do the
following:
1.
Press ENTER to toggle between three settings:
•
“IS INCREMENTED IN ALL MODES” – Parts and batch counters will increment on
every stroke no matter what mode (i.e., Inch, Single-stroke, or Continuous) you are in.
•
“NOT INCREMENTED IN INCH MODE”–The Parts counter and batch counters
whose increment mode is programmed as GOOD PARTS will not increment when you
are in Inch mode.
•
“NOT INCREMENTED IN INCH MODE OR INT. STROKE MODE”–The Parts
counter and batch counters whose increment mode is programmed as GOOD PARTS
will not increment when you are in Inch mode or when there is an Interrupted Stroke.
2.
When the setting you want is displayed, press RESET.
Counter Increment Mode
(INITIALIZATION – POSITION SENSOR)
This item, which is provided for SFC (see Appendix H) and LETS (see Appendix I)
customers, allows you to specify whether the Good Parts counter increments during a fault
condition. The default setting, NO INC FAULT, prevents the counter from incrementing
when there is a fault. To set this parameter, do the following:
1.
Press ENTER to toggle between two settings:
•
“NO INC FAULT” – The Parts counter and batch counters whose increment mode is
programmed as GOOD PARTS will increment on every stroke except when there is a
fault condition. This is the default setting.
•
“INC ALWAYS”–The Parts counter and batch counters whose increment mode is
programmed as GOOD PARTS will increment on every stroke even if a fault condition
is present.
2.
When the setting you want is displayed, press RESET.
The Strokes counter will increment regardless of the mode you are in.
NOTICE