Wintriss dipro 1500, User Manual

Page: 94 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 85 Ch 5 1092000
2. Select the tool number you want to change. You will see a display like this:
TOOL NUMBER 8600
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
LOAD THE TOOL INFORMATION
MODIFY THE TOOL INFORMATION
DELETE THE TOOL INFORMATION
3. Select "Modify the tool information". You will see this display:
TOOL# 8600
SET COUNTERS
SET SENSORS
SET CAMS
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
Modifying sensor settings
1. Select "Set sensors" from the display above. You will see your list of
sensors for the tool. (Your display will show different sensor names.)
DIE PROTECTION
SENSORS FOR
TOOL # 8600
USE CURSOR KEYS TO
MAKE SELECTION
PRESS ENTER TO SELECT
PRESS RESET WHEN DONE
PART EJECTION
END OF STOCK
OVERFEED
OIL PRESSURE
STOCK WIDTH
MISFEED PILOT #1
PART EJECTION
2. To change a setting, select the sensor you want to change. Then modify set-
tings in the same way you originally made them. See "Making sensor settings
for a tool" earlier in this chapter. You can change any setting for a sensor. Or
you can leave any setting the same by not changing the selection already
made. (When you change sensor type, you have to reset the ready signal).
3. When you are done making changes, display your list of sensors, then press
RESET to see the display to select other settings (counters, cam channels).
If you press RESET again–and the tool number you changed is loaded–you
will see a display allowing you to immediately reload the tool number with
the new settings. If the tool number you changed is not loaded, you will see
the display allowing you to load, modify, or delete the tool number. Press
RESET once more and you go back to the Programming menu.