Wintriss dipro 1500, User Manual

Page: 55 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 46 Ch 2 1092000
Installing high speed version of DiPro 1500 (optional)
If you have a standard DiPro 1500 and wish to change the system to a high speed version
(1600 SPM maximum), follow these instructions:
Moving the jumper:
1. See Figure 2-4 for the location of the jumper J101. Notice that the jumper is set on
pins 2 and 3 (for 800 SPM).
2. Move the jumper so that it will be on pins 1 and 2 (for 1600 SPM).
Upgrading the firmware:
1. Verify that power has been turned off to DiPro 1500! The LCD display on the
front panel should be blank and the angle/RPM display should be unlit.
2. Open the front cover by unlocking the latch on the side, loosening the two cover
screws and sliding back the two hold down clips.
3. Locate the firmware chip (see Figure 2-4). The firmware chip has a label on it.
4. Note the orientation of the firmware chip. There is a semi-circular notch on the bottom
of the chip. When you replace the chip, the notch on the new chip MUST also be face
down.
5. Insert a small screwdriver between the bottom of the chip and the socket and carefully
pry the chip out of its socket. Be careful not to get the screwdriver under the socket
itself. Put the chip aside.
6. Open the package containing the new firmware chip. Before you remove the chip from
the package, you should ground yourself by touching any large metal object (the press
will do nicely). This will remove any static electricity that you may be carrying around.
A static electricity "zap" will destroy the chip.
7. Once you are "grounded", remove the chip from its holder. Orient the chip so that the
notch faces downward. If you plug the chip in backwards, it will be destroyed.
8. Plug the chip into its socket by first plugging in the left row of pins and then aligning the
right row of pins over the socket and pushing straight in .
9. If the two rows of pins are spread too far apart to plug easily into the socket:
A. Hold the chip on its side on a desk or a flat surface with the pins pointing towards you.
B. Being careful NOT to overbend the pins, gently flex the top of the chip towards you.
Turn the chip over so that the other row of pins is now on the desk pointing towards
you. Flex it again, thus bending the other row of pins towards eachother.
C. Try plugging the chip into the socket again, as in Step 8. If necessary, repeat Steps A
and B.
10. Make sure that the notch in the chip is at the bottom and that all of the pins are in the
socket.
11. Turn the power on and verify the normal operation of the unit. If the unit powers up with
a garbled display or "rolling" LEDs, turn the power off and repeat Step 10. Sometimes
one or more pins are bent and not plugged in properly. If the unit is still malfunctioning,
call Data Instruments for assistance.