Wintriss dipro 1500, User Manual

Page: 39 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 30 Ch 2 1092000
7. First connect the ground (green or green/yellow) wire. It must be connected to the
ground block as shown in Figure 2-10, not to "GND" terminal on the connector.
The ground block is located on the wall of the enclosure just above the connector
as shown. To connect to ground block, strip ground wire about 1/4" (6.4 mm)
from end, loosen screw on block, slide wire in hole, and tighten screw to pin wire
in place.
factory installed
ground wire to
case lug
Ground block.
Connect ground
(green) wire here.
ground wire (green)
TB104
HI NEU GND
IN
A IN
B
CHAS
TOP
STOP
{
EMER
STOP
{
1 2 3 4 5 6
7 8 9 10
Figure 2-10. Connector and ground block for AC power.
8. Now find the connector TB104 for the other AC wires and stop circuits. It should
be plugged into the socket.
NOTE: A ground wire is attached from the connector to a case lug as shown in
Figure 2-10. Leave the ground wire attached to the connector while making
connections.
If you remove this wire in order to pull the connector all the way out
of the enclosure, be sure to replace it when done.
9. Connect power wires as shown in Figure 2-10. For 115 Vac, connect black wire
to HI terminal and white wire to NEU. (For 230 Vac connect black wire to HI
terminal and red wire to NEU). Attach wires the same way you did for resolver
and RCB wires.
NOTE:
Make sure you do not start at the wrong end of the connector. Put it over
the socket the way it will plug in and note wire markings next to the socket before
starting.
10. Connect wires from the press control top stop circuit to the terminals marked top
stop (7 and 8). It does not matter which way you connect the wires.
11. Connect wires from the press control emergency stop circuit to the terminals
marked "emer stop" (9 and 10). It does not matter which way you connect the wires.
12. Connect wires for the input check circuit to the terminals marked "IN A" and "IN
B." It does not matter which way you connect the wires. Se Figure 2-8.