Wintriss dipro 1500, User Manual

Page: 15 / 129

Introduction to DiPro 1500
DiPro 1500 User Manual 6 Ch 1 1092000
Connection boxes for sensors
Instead of using the side panel inputs on DiPro 1500, you can use one of two optional
interface boxes to connect sensors to DiPro—the Remote Connection Box (RCB) or the
DiPro Sensor Interface or Wintriss Sensor Interface. They can be mounted near the die,
eliminating long sensor leads and making it easy to switch sensors between jobs. Refer
to either the DiPro Sensor Interface or Wintriss Sensor Interface user manual for more
information.
The DiPro Remote Connection Box (RCB)
has six quick connectors. The RCB is
wired permanently to DiPro.
SENSOR INPUTS
1 2 3
4 5 6
GND
DiPro RCB
®
®
DATA INSTRUMENTS
WINTRISS CONTROLS GROUP
1
2
3
Figure 1-3. Remote Connection Box (RCB)
RCB Dimensions.
Width (does not include width of flanges): 4.56" (11.6 cm);
Depth: 2.56" (6.5 cm); Height: 4.06" (10.3 cm); Overall width (includes width of
both flanges): 5.75" (14.6 cm); Vertical distance between mounting holes (center
to center: 3.25" (8.3 cm); Horizontal distance: 5.25" (13.3 cm).
RCB cable (30 or 100 ft) is attached. Eight wires in cable are factory installed on
RCB end (one for each sensor plus ground connection, one wire not used). Wires
are connected to DiPro I/O Assembly in controller. (See Chapter 2 for wiring.)
1. The RCB has six banana jacks for connecting sensors. It also has three Lumberg
twistlock connectors for use with many types of electronic sensors. You have the
choice of using the banana jacks or Lumberg connectors for inputs 1, 2, and 3.
2. Ground jack on RCB box.
3. Flange and mounting holes for attaching RCB to press.