Wintriss dipro 1500, User Manual

Page: 72 / 129

Using DiPro 1500 in Initialization mode
DiPro 1500 User Manual 63 Ch 4 1092000
If a position sensor is installed
You use this menu item only after the position sensor is installed to turn the position
sensor on and check operation. See "Install position sensor" in Chapter 2 for more
information on the position sensor and how to use this menu choice.
If no position sensor is installed
If you do not use a position sensor, you should see this display when you select
"position sensor". This is the factory setting:
POSITION SENSOR SWITCH OPEN
PRESS ENTER KEY TO CHANGE MODE
PRESS RESET WHEN DONE
POSITION SENSOR DISABLED
If the message says "position sensor enabled", press ENTER. The message will then
correctly say, "position sensor disabled". Then press RESET to return to the
Initialization menu.
Communications
This choice on the Initialization menu lets you set an identification number for your unit
if you are using a computer to collect data from DiPro. DiPro 1500 can send and receive
data from a computer using Wintriss Controls' PACNet
®
pressroom monitoring software.
If you do not use PACNet, ignore this item.
If you are using PACNet, select "communications" to set the number. You will see this
display:
CPU NUMBER = 1
PRESS CURSOR KEYS TO CHANGE CPU NUMBER
PRESS RESET WHEN DONE
The number shown is the identifying number of your unit. For instance, if you had many
DiPros, you would identify them as 1, 2, 3, 4, etc.
To change the number, use the "up" and "down" cursor keys. The "UP" key increases the
number, the "DOWN" key decreases it. Set an identifying number for the unit. See your
PACNet manual for more information on what number to use. Then press RESET to go
back to the Initialization menu. Refer to the PACNet user manual for more information.