Wintriss dipro 1500, User Manual

Page: 28 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 19 Ch 2 1092000
Mounting the DiPro 1500 control enclosure
IMPORTANT!
If you have a panel mount, go to Appendix A
for special installation instructions, and
mounting and cutout dimensions.
To mount the enclosure, follow these steps:
1. Determine a convenient place for the control enclosure. Ideally it should be close
to the press control so operators and setup personnel can easily see the readouts
and reach the keyboard. Make sure all cables will reach. Leave enough room to
open the door at least 120°. The enclosure can be mounted to the press or on a
free-standing pedestal.
IMPORTANT:
The enclosure should be installed at a convenient height for all
users. An ideal height is to have the top edge of the enclosure at approximately
chin level. You should also consider mounting the enclosure on a stand or
platform so it tilts back about 30° from the vertical. This makes it easier to see the
display and use the keyboard. Experiment to determine a good height for
everybody before mounting.
2. Drill holes for mounting (see dimensions in Figure 2-2). Shockmount studs are
1/4–20. Tap holes (if necessary) and mount the enclosure using the enclosed
shock mounts. Use a No. 7 drill and 1/4–20 tap.
0° 90° 180° 270° 360°
Contrast
100 Discovery Way, ACTON, MA 01720 USA
DATA INSTRUMENTS
WINTRISS CONTROLS GROUP
CURSOR ANGLE
ON
OFF
ANGLE/
SPM
RESET
ENTER
RUN
PROGRAM
DiPro 1500
WINTRISS DIE PROTECTION
8"
20.3 cm
12.75"
(32.4 cm)
Figure 2-2. DiPro mounting dimensions (for control enclosure)