Wintriss dipro 1500, User Manual

Page: 49 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 40 Ch 2 1092000
Power-up prechecks
You are almost ready to turn on DiPro. Before continuing, make sure you have
completed all the procedures in this chapter up to here. Then go through the checklist
below to make sure DiPro is wired correctly.
Check these items before turning DiPro on
_______ Is the DiPro 1500 voltage selector switch set for the right
voltage—115 Vac or 230 Vac )? See Figure 2-9.
_______ Is the resolver cable wired to the connector correctly. See
Figure 2-5.
______ Is there an output relay for each wired output terminal?
(Cam users only).
Everything checked? Now, if you installed the cam relay enclosure, pull the connector at
TB301 out of its socket. This prevents any equipment from running when you turn DiPro
on. We will check out this part of the unit later.
For those who are installing the position sensor, remember that we ran wires to the
enclosure for it but have not yet connected the wires. Tape the ends of these wires and
push them into the lower corner of the enclosure (get them out of the way for now). We
will attach these wires after zeroing the resolver.
Connect AC power wires from DiPro to power
source
Connect AC power wires from connector TB104 in DiPro to power source. Be sure
power is off at terminals you are connecting wires to.
Turn on power to DiPro and check display
Turn on power to DiPro and go into Initialization mode. To do this, turn the
Program/Run key to "program", and then press both the left and right "ANGLE-OFF"
keys at the same time for one second (See "Using the keyboard" - Chapter 3, and "Using
DiPro 1500 in Initialization Mode" - Chapter 4).
You should see this display on your screen. This is the Initialization menu - the first
display in the Initialization mode.
INITIALIZATION
MENU
USE CURSOR KEYS TO SELECT, ENTER TO SET.
SWITCH TO RUN WHEN DONE.
RESOLVER ZERO
POSITION SENSOR
COMMUNICATIONS
SELECT CAM NAMES
SECURITY ACCESS