Wintriss dipro 1500, User Manual

Page: 16 / 129

Introduction to DiPro 1500
DiPro 1500 User Manual 7 Ch 1 1092000
The DiPro Sensor Interface
is also an option with DiPro. The DiPro Sensor
Interface has 8 inputs for sensors. It also has its own 24V power supply so you
can use it to power your electronic sensors. LED indicators show the on-off
status of each sensor input.
Wiring connections from the DiPro Sensor Interface
to DiPro 1500 are shown in Chapter 2. However, installation of DiPro Sensor
Interface is not covered in this manual. If you purchase DiPro Sensor Interface to
use with your DiPro 1500, you will also receive the
DiPro Sensor Interface user
manual. The manual tells how you how to install and use it. Refer to that manual
for details.
Connecting DiPro cam channels to your
equipment
If you purchased the programmable cam option with DiPro, you have received a separate
box for wiring the cam channels to your equipment. The box contains the relay modules
that will open and close on signal from DiPro to turn your equipment on and off. You
wire it to the main DiPro assembly. Different types of relays can be used depending on
the voltages of your equipment and your special needs.
WARNING!
DiPro 1500 should not be used to control clutch / brake timing.
It is designed to be used for auxiliary functions only.
Settings you can make on DiPro
All settings are made using the keys on the DiPro keyboard. Up to six sensors can be
used with DiPro. If the programmable cam switch option is installed, four channels for
controlling press equipment are available. For complete instructions on how to make
settings, see Chapter 4—Programming. Here are settings you can make:
•
Assign tool numbers for tools .
You assign a tool number to your settings for a
tool. This is how you keep track of all settings you make.
•
Set green sensors
. You set the ready signal (portion of the stroke where the
sensor must actuate). You also set stop type (top stop or emergency stop) and
sensor function. DiPro signals the press to stop if it does not receive a signal from
the sensor during the portion of the stroke set. There are three types of green
sensors on DiPro—green, green quick check, and green constant. See "Sensor
terminology" for definitions.
•
Set green special sensors
. You set the maximum number of strokes that the press
can make without this sensor actuating. You also set the sensor function. See
"Sensor terminology" for a description of the sensor.
•
Set yellow sensors.
You set stop type (top stop or emergency stop) and sensor
function. A yellow sensor is always normally open to ground (ungrounded).
•
Set red sensors.
You set stop type (top stop or emergency stop) and sensor
function. A red sensor is always normally closed to ground (grounded).