Wintriss dipro 1500, User Manual

Page: 51 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 42 Ch 2 1092000
PRESS ENTER KEY TO ZERO RESOLVER
PRESS RESET WHEN DONE
CURRENT RESOLVER ZERO POSITION IS 0
There will not be any number displayed until the resolver is zeroed. Look at the LED
readout. It will now show the resolver position. If the resolver is anywhere
between 330° and 30°, you can go to step 3. DiPro will automatically correct the
offset and the angle readouts will indicate the true angle of the ram.
If the resolver is outside the range of 330° to 30°, you will have to turn the
resolver shaft by hand until the LED display shows zero. The press must be at top
dead center before you do this. Loosen the tension on your drive belt or chain and
turn the resolver shaft by hand until the reading on the Angle/SPM readout is 0°.
It does not matter which way you turn the shaft. Set the resolver right at 0 (so the
readout shows 0°).
Once the resolver is set, tighten the drive mechanism, and go to Step 3.
3. To zero, make sure the display shown in Step 2 is on your screen. Double check
that the readout is between 330° and 30°. Then press ENTER. You will see a
display like this (in this example, angle is 356°):
PRESS ENTER KEY TO ZERO RESOLVER
PRESS RESET WHEN DONE
CURRENT RESOLVER ZERO POSITION IS 356
The number shown will be the zero position of the resolver. DiPro electronically
adds or subtracts the offset (4 in our example) so it always knows the true zero
position of the ram. If the number is 0, it means the zero position of the resolver at
TDC is 0°.
4. Press RESET to go back to the Initialization Menu. You are done. If you are
installing the position sensor, do it next. If not, go to "final checkout".