Wintriss dipro 1500, User Manual

Page: 80 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 71 Ch 5 1092000
3. Key in the number for the tool. The messages at the bottom of the display
tell you how to enter the number. (See "Entering a number with the cursor
keys" in Chapter 3 for step-by-step instructions.)
4. Press ENTER after keying in the tool number. You will see this display. The
tool number is shown at the top left. (In this example, the tool number is
4400).
TOOL# 4400
SET COUNTERS
SET SENSORS
SET CAMS
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
5. Select "Set sensors". You will see this display. This is your list of sensors.
DIE PROTECTION
SENSORS FOR
TOOL # 4400
USE CURSOR KEYS TO
MAKE SELECTION
PRESS ENTER TO SELECT
PRESS RESET WHEN DONE
SENSOR 1
SENSOR 2
SENSOR 3
SENSOR 4
SENSOR 5
SENSOR 6
SENSOR 1
6. You can select any sensor, but it is a good idea to start with the first sensor.
Select "sensor 1" (which is already highlighted). After selecting it, the first
thing you do is name it.
Naming the sensor
You see this display when you select a sensor. It allows you to name the sensor.
SELECT NAME FOR
DIPRO SENSOR 1
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
UNNAMED
AIR PRESSURE
CLAMP PRESSURE
DIE OVERLOAD
END OF STOCK MORE NAMES