Wintriss dipro 1500, User Manual

Page: 91 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 82 Ch 5 1092000
3. Select "Load the tool information". You will see this warning message:
TOOL# 8600
*****************************************************************
WARNING! ANCILLARY EQUIPMENT MAY OPERATE
WHEN THIS SETUP IS LOADED. WARN ALL
PERSONNEL TO STAND CLEAR.
*****************************************************************
PRESS ENTER TO LOAD THE SETUP
PRESS RESET TO CANCEL
4. Press ENTER to load the tool settings (a setup). You can go back without
loading the tool settings by pressing RESET. Once the tool number is
loaded (which takes only a few seconds), you will return to the
programming menu.
Note that the programming menu shows the tool number you just loaded.
You can always check which tool number is loaded on this display. With
settings loaded, you can switch to Run mode and run the press.
Delete the tool information
When you delete a tool number, you remove it from the tool number display and
from DiPro's memory. All tool information will be lost.
To delete a tool number:
1. Select "Program/load tool numbers" from the programming menu (first
display in Program mode). To select, highlight the item and press enter.
2. Select the tool number you want to delete from the tool number display.
You will see this display:
TOOL NUMBER 8600
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
LOAD THE TOOL INFORMATION
MODIFY THE TOOL INFORMATION
DELETE THE TOOL INFORMATION
3. Select "Delete the tool information". Say you were deleting tool number
8600. You would see this message:
ARE YOU SURE YOU WANT TO DELETE TOOL NUMBER 6800?
PRESS ENTER TO DELETE
PRESS RESET TO CANCEL
4.
Delete the tool number by pressing ENTER. To go back without deleting
the tool number, press RESET.