Wintriss dipro 1500, User Manual

Page: 90 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 81 Ch 5 1092000
Load the tool information
Before you run the press, you have to load the DiPro settings for the tool being
used. This puts the settings for the tool in a place in DiPro's electronic memory
where it can use the settings to monitor the press.
WARNING
Equipment may operate
when you load tool settings
When you load tool settings, both the DiPro and cam
timing settings for the tool are loaded if you have the
DiPro 1500 cam timing option installed. When the cam
timing settings are loaded, auxiliary press equipment (a
feed, transfer mechanism, lubricator, etc.) may start if the
press crankshaft is within the on-off setting for that
device. All employees must stay away from the press and
equipment that the cam operates before tool settings are
loaded.
To load the settings for a tool number:
1. Select "Program/load tool numbers" from the programming menu —the first
display in programming mode. To select, highlight the item and press
ENTER.
NOTE: you can also load tool numbers in Run mode.
2. Select the tool number you want to load from the tool number display. After
selecting the tool number, you will see a display like this:
TOOL NUMBER 8600
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
LOAD THE TOOL INFORMATION
MODIFY THE TOOL INFORMATION
DELETE THE TOOL INFORMATION