Wintriss dipro 1500, User Manual

Page: 100 / 129

Using DiPro 1500 in Run mode
DiPro 1500 User Manual 91 Ch 6 1092000
Counters
To set or adjust counters in Run mode, select "Counters" from the run menu. You
will see this display:
COUNT PRESET VALUE
BATCH
PRESS ENTER TO SET COUNTER
PRESS RESET WHEN DONE
TOTAL HITS
USE CURSOR KEYS TO MAKE SELECTION
GOOD PARTS 51302
200000
10000
9405
1230450
Now you can change counters or reset the good parts and batch counters in exactly
the same way you do when you first set them.
You cannot adjust the total hits
counter. See "set counters" in Chapter 5.
Show sensors
"Show sensors" allows you to see the status of all your sensors at once. You can use
it while the press is running or stopped. When you select "Show sensors", you see a
display like this:
SENSOR STATUS
1 2 3 4 5 6
G GCON RED GQC YEL GS11
Ground block
(indicates sensor
grounded)
Letter(s)
indicates
sensor type
number indicates
max. strokes
allowed for
green special
PRESS RESET WHEN DONE
The display shows the status of every sensor for a loaded tool number. The six
sensor inputs are indicated by the numbers 1-6.
The type of sensor connected to each input is indicated by the letters (and/or
numbers) under the numbered inputs. G=green; GCON=green constant; RED is a
red sensor; GQC=green quick check; YEL=yellow; GS=green special (11 represents
maximum number of strokes allowed); N/U=not used.
The ground block above a sensor indicates that it is grounded.