Wintriss dipro 1500, User Manual

Page: 88 / 129

Using DiPro 1500 in Program mode
DiPro 1500 User Manual 79 Ch 5 1092000
3. Use the right "on" angle key to set the degrees where the channel should turn
on. The letter "T" and the 0 next to it will move across the scale at the bottom
of the display as the key is pressed. Hold down the key until the "T" moves to
the degrees that you want. If you overshoot your setting, press the left "on"
angle key to go back. The degrees setting is also shown in the box next to
"angle".
NOTE: The 0 (zero) next to the "T" indicates the "on-time" which is set next.
4. Use the "angle off" keys to set the time that the channel should be on in
milliseconds (A millisecond is 1/1000th of a second). Press the right "angle
off" key until you reach the right number. The number will change in
increments of 10 missiseconds. If you overshoot, use the left "angle off" key to
go back. The number is shown in the box and next to the "T" on the scale. You
can go up to 500 milliseconds (.5 second).
5. When you are done with the setting, your display should look like this (the
setings here are 270° on, 250 mS "on-time"):
TOOL# 4400 PART BLOW OFF
0° 90° 180° 270° 360°
USE THE ANGLE KEYS TO SET
START ANGLE. USE OFF ANGLE
KEYS TO SET DURATION (MSEC).
PRESS RESET WHEN DONE.
ANGLE 270°
TIME 250
T250
time when channel
comes on
time channel stays on
"T" and number move
across screen when you
press angle keys
6. Press RESET to go back to the list of channel names.
Setting other channels for the tool
When you are done setting one channel, make settings for the rest of your channels.
To finish making settings:
1. Choose the next channel from the list of channel names. Make settings for
the channel. Then make settings for all your other channels.
2. When you are done with all channels, display the list of channels. Then
press RESET. You will return to the display allowing you the choice of
setting counters, sensors, or cams. You can start other tasks. If you press
RESET again, you will return to the first display in Programming mode.
Delete channel settings
To delete settings for a cam channel, select the cam channel, then select "Delete
channel settings" from the next display.
The settings for the channel will go back to 0 on—0 off. You will automatically go
back to the list of cam channels.