Wintriss dipro 1500, User Manual

Page: 34 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 25 Ch 2 1092000
Wiring a remote reset switch or setup mode
disable circuit
Connector TB101 has two terminals for wiring a remote reset switch and a setup mode
disable circuit. The setup mode disable circuit allows you to disable green sensors only
using a remote switch. Typically the circuit is connected to the "inch" position of your
clutch/brake control. Then when you inch the press, DiPro will not stop the press when a
green sensor signals a fault. Both the setup mode terminal and remote reset terminal can
be wired to equipment you choose or you can just use a simple switch to activate each
circuit.
Connector TB101 also contains the terminals for the RCB. You will wire the RCB in the
next step if used. Therefore, if you plan to use a remote reset switch or the setup mode
circuit, plan how you will run your wiring for this connector now so you do not have to
disconnect conduit or rethread wires through conduit later. Connect wires as instructed
below.
To connect a remote reset switch
Connect a wire from TB101, terminal 8, to a normally open switch. Connect another wire
from the switch to Gnd (TB101, terminal 11). DiPro 1500 is reset with a momentary
connection to ground.
To connect the setup mode circuit
1. Connect a wire from TB101, terminal 7 to the "inch" circuit of your press control or
to another device you choose. Connect another wire from the switch to Gnd (TB101,
terminal 11). DiPro 1500 goes into "setup mode" as long as terminal 7 is grounded.
Refer to your electrical prints or the manual for your press control to plan your
wiring.
2. Connect another wire from the inch circuit or switch to GND (TB101, terminal 11).
Make sure the circuit is connected so the "setup mode" input is pulled to ground
when the press control is set to inch and is open when not in inch.
Green sensors are disabled when the circuit is grounded. The good parts and batch
counters are also disabled.