Wintriss dipro 1500, User Manual

Page: 33 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 24 Ch 2 1092000
Multiple controls connected to a single resolver
You can connect DiPro 1500's resolver to as many as three other controls (for instance -
Spectrum, ProCam 1500, or another DiPro 1500).
IMPORTANT!
Any Wintriss Controls product that is providing press control timing signals to a clutch/brake
control must always be MASTER. In general, if there is either a Spectrum or ProCam 1500
involved in addition to DiPro 1500, DiPro 1500 will always be SLAVE, and either Spectrum or
ProCam 1500 can be MASTER.
1. See Figure 2-4 for the location of the resolver connector TB105 and the jumper
J102.
2. Locate the 6-conductor shielded resolver cable. Run the cable through 1/2"
conduit from TB105 to the bottom right knockout of the "master" unit. If there is
a connector on the other end, cut it off.
3. Pull connector TB105 in the "master" unit out of its socket.
4. Attach the wires to the connector as shown in Figure 2-5. You will be wiring in
parallel (#4 red to red, #5 yellow to yellow, etc.), so that when you are finished,
you should have two wires of the same color connected to each terminal on
TB105. To connect a wire, refer to Step 5 in "To wire the resolver". Also see
Figure 2-6.
5. Connect the cable from TB105 in the "master" unit to TB105 in the first "slave"
unit. Remember to wire in parallel. If there is an additional "slave" unit, again
wire from TB105 to TB105 in parallel.
6.
See that the jumper J102 on the control board of the "master" unit is set so that it
is on pins 1 and 2, "master" position. Locate J102 on the control board of the
other "slave" units. Move each of those jumpers to pins 2 and 3, "slave".