Wintriss dipro 1500, User Manual

Page: 68 / 129

About the keyboard and displays
DiPro 1500 User Manual 59 Ch 3 1092000
A bar now appears from 0 to 360. The ready signal box shows on at 1, off at
0. The bar shows this graphically. At this point, the ready signal is on for the
whole stroke.
NOTE :
Remember, the 0 point and the 360 point on the scale beneath the
screen are the same point.
Continue to push the right
( )
"angle on" key. You can hold it down and the
bar will keep moving until you let up. The left edge of the bar moves to the
right. Stop when the left edge is at 270°. Check the "on" setting in the box. It
should show 270°. If you go too far, use the left
( )
"angle on" key to back
up. You will see this display:
SENSOR 1 PART EJECTION GREEN
USE ANGLE KEYS
TO SET THE READY
SIGNAL. PRESS
RESET WHEN
DONE
0 90 180 270 360
270
0
ON
OFF
READY
Left edge of bar
now at 270. This is
the "ready on"
setting.
Now your ready signal is on at 270°, off at 0°.
Setting ready off
To make the "off" setting, press the right
( )
"angle off" key. You can hold it
down so the bar keeps moving. The bar will wrap around and begin to extend
from 0 towards 90°. Stop when the bar reaches 20°. This is the required setting.
Look to see that "ready off" in the box shows 20°. If you go too far, use the left
( )
"angle off" key to back up. The display will look like this:
SENSOR 1 PART EJECTION GREEN
USE ANGLE KEYS
TO SET THE READY
SIGNAL. PRESS
RESET WHEN
DONE
0 90 180 270 360
270
20
ON
OFF
READY
Right edge of bar
wraps around 360°
and moves to 20°.
This is the final
setting, as shown
in the box.
You are done making the on-off setting for the sensor. You can adjust this setting
any time you want using the "angle on" and "off" keys. The on and off setting
will always show in the "ready" box. Making the on-off setting for cam channels
(if you have the cam switch installed), is done exactly the same way.