Wintriss dipro 1500, User Manual

Page: 47 / 129

DiPro 1500 Installation
DiPro 1500 User Manual 38 Ch 2 1092000
4. Find the cable that runs from the programmable cam output connector TB102
inside DiPro to TB301 in the output enclosure. The cable has ten wires. You will
use only seven cable wires. If you are using between five and eight channels, you
will use the four other terminals on TB102, marked MU (for channel 5), AB (for
channel 6), JF (for channel 7), AW (for channel 8). These will be connected to a
second output assembly. Refer to Table 2-3B for proper wiring.
5. Attach one end of the cable to the connector for TB102. See Table 2-3B for
wiring. (The connector should be plugged into the socket.)
6. Run the cable through conduit to TB301 in the relay enclosure. You can use the
knockouts directly below the connectors on each enclosure.
7. Attach the other end of the cable to the connector for TB301. See Table 2-3B.
Note that this socket has only eight terminals. A wire from CHAS to a lug on the
relay enclosure should already be connected (unless you bought the board only).
Table 2-3B. DiPro TB102 to output enclosure(s) TB301
(PIN #)
Box #1 TB301
Wire
Brown
Purple
Orange
Yellow
CH 1 (1)
CH 2 (2)
CH 3 (3)
CH 4 (4)
–12V OUT (10)
+5V OUT (9)
GND (11)
CH 1 (1)
CH 2 (2)
CH 3 (3)
CH 4 (4)
+5V
A
B
Red
Black
Green
Other wires on cable (white, gray, blue) not used. These
can be cut off where they exit cable.
Brown
Purple
Orange
Yellow
CH 5 (5, MU)
CH 6 (6, AB)
CH 7 (7, JF)
CH 8 (8, AW)
DiPro TB102 Box #2 TB301
CH 5 (1)
CH 6 (2)
CH 7 (3)
CH 8 (4)
+5V
A
B
(PIN #) (PIN #)
opt CHAS
GND (8) opt CHAS
GND (8)
8. Plug cable connectors into their sockets.
9. To connect the relays to your equipment, use connector TB302. See Figure 2-
12B.