VeEX MPA, User Manual

Page: 673 / 842

Protocol Tabs
673
recorded in the Results Errors/Alarms screens, Event
Log nor Performance Monitoring screens, however the
corresponding event's LED will still turn red.
Pressing Clear History or Restarting a new test will
clear all LED history.
LED Quick Status Area
(Specifically for Fibre Channel SAN testing on the Packet tab)
The left side of the screen provides an at-a-glance view of the current protocol
processor's LEDs and Laser ON/Off button. The LEDs report incoming error and alarm
activity, current status, and event history to help narrow the focus if problems are
detected on the incoming signal and provide a starting point when trying to diagnose
problems..
This portion of the screen allows you to quickly scan and target potential problem areas.
The
LED Quick Status Area contains the following areas:
•
Laser On/Off button: Enables you to turn the laser on and off.
If no SFP module is installed, the button will state “No Laser”.
•
TX: Displays the transmit interface configuration, such as rate, wavelength,
framing, and/or duplex depending on the specific protocol processor
If a non-Packet interface is selected from one of the other protocol tabs, then
"Not Assigned" will be displayed.
If a laser module is not inserted then "No Laser" will be displayed.
•
RX: Displays the received optical power in dBm. This status indicator will flash
when one or more received Optical Lanes' power level exceeds the laser
module's Power Warm or Power Hot thresholds.
For MPM cards that have an MLD tab this is an aggregate broadband power
value, based on the combined power levels from all of the laser module's received
Optical Lanes. See the
MLD Receive - SIG screen for individual Optical Lane
power levels.
•
E/A: Indicates the current Error / Alarm configured for transmission. This is a
status indicator.
MPA_e_manual_D07-00-129P_RevA00