VeEX MPA, User Manual

Page: 215 / 842

Protocol Tabs
215
ODU:TCM6 TTI ODU:TCM ACT OPU:RES 3
ODU:TCM1 BIP ODU:FTFL
ODU:TCM2 BIP ODU:PM TTI
Capture Trigger Select the Capture Trigger event.
FRAME ERROR OTU:IAE ALARM
BIT ERROR OTU:BDI ALARM
FEC:CORR ERROR OTU:AIS ALARM
FEC:UNCORR ERROR ODU:OCI ALARM
MFAS ERROR ODU:LCK ALARM
OTU:BIP8 ERROR ODU:BDI ALARM
OTU:BEI ERROR POS JUSTIFY
ODU:BIP8 ERROR NEG JUSTIFY
ODU:BEI ERROR BYTE EQUAL
LOM ALARM BYTE NOT EQUAL
OOM ALARM MANUAL
Match Value Use the keypad to enter the byte value (in Hex) that the
selected byte's received value will either need to "equal" or
"not equal" in order to trigger the capture event.
This setting only appears when the Capture Trigger is set
to "BYTE EQUAL" or "BYTE NOT EQUAL".
Bytes After Trigger When a Capture event has been triggered, 256 overhead
byte values will be captured (from 0 to 255).
This setting is used to specify how many of those 256 bytes
should be captured immediately following the trigger, and in
turn how many of those 256 bytes should be captured
immediately preceding the trigger.
If 255 is entered (default), then the triggered byte value,
and the following 255 byte values after the trigger event will
be captured.
If 254 is entered (default), then the one byte immediately
preceding the trigger, the triggered byte value, and the
MPA_e_manual_D07-00-129P_RevA00