VeEX MPA, User Manual

Page: 604 / 842

Packet Tab
604
Negotiation is an Ethernet handshaking mechanism that looks at the incoming signal
and determines the link speed and duplex mode (full-duplex or half-duplex). The
Negotiate button enables or disables negotiation mode.
When auto negotiation is first enabled, it attempts to negotiate the link with a remote
device. After successful negotiation, negotiation will not be performed again unless the
remote device initiates an auto negotiation sequence.
By disabling auto negotiation, the test set can simulate older Ethernet equipment that
does not support auto negotiation logic.
The Negotiate setting is only available for 1G and 2.5G Optical Ethernet rates
and 10M and 100M Electrical rates.
To enable auto negotiation:
1. Select the Packet tab.
2. Select Config and choose SET .
3. If the current Interface rate (or Mode ) needs to be changed, then configure the
setting for the desired rate.
4. Select Negotiate and choose Enabled .
•
When first enabled, the Status displays "Enabled" and "Pending link".
•
Upon successful negotiation with a remote device, the Status displays the
negotiated Interface Rate and Duplex mode.
To disable auto negotiation:
1. Select Negotiate and choose Disable .
•
When disabled, the Status displays "Disabled".
How to use the Ramp Mode for Ethernet Traffic Generation
What is Ramp Mode?
Ramp Mode is an Ethernet Traffic Generation method that continuously steps up and
down the transmit bandwidth, or Mbps rate.
MPA_e_manual_D07-00-129P_RevA00