Tektronix PHASER 380, Service Manual

Page: 259 / 346

Service Manual 8-53
Field Replaceable Unit Disassembly/Assembly
8
Rollers
Exit roller
1. Turn off the printer and remove the power cord.
2. Remove the right-side and left-side covers as explained in the earlier
topic, “Cabinet panels and covers” on page 8-4.
3. Remove the exit cover as described in the earlier procedure “Cabinet
panels and covers” on page 8-4.
4. Disconnect the cables from I/O board 3 and then remove it.
Removing I/O board 3 is discussed in the later topic “I/O board 2 and
I/O board 3” on page 8-65.
5. Remove the exit roller drive train by removing the two E-clips
securing it in place. Note for reassembly how it is spring-loaded to the
engine frame and how the flat washers are located under the E-clip.
Tools required
■
Magnetic screwdriver
■
Needle nose-pliers
■
#2 Phillips tip
■
Small, flatblade screwdriver