Tektronix PHASER 380, Service Manual

Page: 313 / 346

Service Manual 9-33
Checks and Adjustments
9
9. Scroll to the menu item Set Skip Value. Use the arrow buttons to
increment or decrement the displayed value by the amount you
estimated in Step 7.
10. make another Skip Calibration image to verify if the adjustment is
correct. Repeat Steps 5 through 9 as necessary.
11. Exit the menus
When you exit the calibration menu, the new skip value is stored in NVRAM
located on the power control board.
Figure 9-19 Examining a test print for horizontal interleave (skip)
SKIP CALIBRATION IMAGE
See service manual for calibration instructions.
Current skip offset: 500
Set skip value
so lines are
evenly spaced
9661-119
Incorrect
Correct