Tektronix PHASER 380, Service Manual

Page: 77 / 346

Service Manual 2-39
Installing the Printer and Drivers
2
Configuring the printer's serial port for a PC
Use the PostScript command file DEVPARAM.PS (located on the Printers
Utilities diskette) to modify the printer’s serial port settings.
The following example sets flow control to Xon/Xoff, parity to none, data bits to 8,
stop bits to 2 and the baud rate to 9600. In the example below, the changes are
persistent across print jobs and across power cycles; they remain in effect until
specifically changed again.
CTRL-D
systemdict/languagelevel known{languagelevel 2 eq
{true (0) startjob dup not
{/exitserver errordict /invalidaccess get exec}
if}{false}ifelse}{false}ifelse
not {quit} if
(%Serial_NV%) <</Password (0)
/FlowControl /X0nXoff
/Parity /None
/DataBits 8
/StopBits 2
/Baud 9600 >> setdevparams
false (0) startjob pop
CTRL-D
Note CTRL-D is the ASCII End-Of-Text (EOT) character.