Tektronix PHASER 380, Service Manual

Page: 47 / 346

Service Manual 2-9
Installing the Printer and Drivers
2
6. Install the printer’s maintenance tray and paper tray. Note that when
a new maintenance tray is installed, the printer requires a 15-to-20
minute wait before it will print.
7. Installing RAM SIMMs . The standard configuration of the printer
includes 16 Mbytes of RAM. This can be supplemented with a 16- or
32-Mbyte RAM SIMM. To install the optional memory, refer to the
topic, “RAM SIMM” on page 8-71.
8. Installing a network card . Network support is provided via three
optional Phaser Share Network Interface plug-in cards.
■
The LocalTalk/Serial Card supports AppleTalk/LocalTalk protocols
and RS-232 serial connectors.
■
The Ethernet Interface Card supports the EtherTalk, Novell NetWare,
and TCP/IP protocols.
■
The Token Ring Network Card supports Novell NetWare, TokenTalk
and TCP/IP protocols.
To install a network card, refer to the topic, “Network card” on
page 8-74.
9. Following RAM SIMM or network card installation, turn on the
printer to ensure that the card works properly. The printer executes a
power-up self-test and prints a startup page. If the printer fails its
self-test, refer to, “Troubleshooting” on page 6-1 The printer may
require up to 20 minutes to warm up from a cold start.
10.
Turn off the printer and connect the printer to a host.