Suzuki GA413, Service Manual

Page: 139 / 1246

3) Remove steering wheel and combination switch assembly, if
necessary. Refer to REMOVAL of STEERING WHEEL and
REMOVAL of COMBINATION SWITCH/CONTACT COIL
AND COMBINATION SWITCH ASSEMBLY in this section.
Perform the following procedure if not removing steering
wheel and/or combination switch assembly.
i) Turn steering wheel so that vehicle’s front tires are at
straight
ahead position.
ii) turn ignition switch to “LOCK” position and remove key.
4) Make alignment marks on upper joint and shaft (column side)
for a guide during installation.
5) Loosen upper joint bolt (lower shaft side) then remove upper
joint bolt (column side).
6) Move upper joint assembly to lower shaft side (in arrow direc-
tion in the figure).
1. Upper joint assembly
2. Upper joint bolt (column side)
3. Upper joint bolt (lower shaft side)
4. Marks
7) Loosen steering column mounting bolts.
1. Steering column mounting bolt
8) If not removing combination switch/contact coil and combina-
tion switch assembly, remove steering column lower and up-
per covers from steering column by removing 3 cover screws.
9) Disconnect all connectors of the following parts.
Combination switch/contact coil and combination switch as-
sembly, if necessary
Ignition switch
P/S system parts (if equipped)
1. Upper cover
2. Lower cover
*: Standard
**: Tapping
10) Remove steering column mounting bolts. Then remove steer-
ing column.
1. Steering column mounting bolt
STEERING WHEEL AND COLUMN 3C-11