Suzuki GA413, Service Manual

Page: 657 / 1246

8) Peel remaining paper from molding.
9) Holding rubber sucker grips, press glass onto body and place
the glass securely by tapping glass surface and molding all
around.
NOTE:
Use care not to damage glass surface or body.
1. Rubber sucker grip
10) Check for water leakage by running water from hose over win-
dow. If leakage is found, dry window and fill leaky point with
adhesive. If water still leaks even after that, remove glass and
start installation procedure all over again.
NOTE:
Do not use high pressure water.
Do not blow compressed air directly at adhesive ap-
plied part when drying.
Do not use infrared lamp or the like for drying.
CAUTION:
Upon completion of installation, note the following.
Sudden closing of door before adhesive is completely
set may cause glass to become loose or to come off.
Therefore, if door is opened or closed before adhesive
is completely set, make sure to open all door glasses
and use proper care.
If molding is not securely in place, hold it down with a
tape until adhesive is completely set.
Each adhesive has its own setting time. Be sure to re-
fer to maker’s instruction, check setting time of adhe-
sive to be used and observe precautions to be taken
before adhesive is set.
Refrain form driving till adhesive is completely set so
as to ensure proper and sufficient adhesion.
11) Install rear view mirror, roof molding, front pillar trims, sunvisor,
garnish and wipers.
BODY SERVICE 9-21