Suzuki GA413, Service Manual

Page: 1119 / 1246

DIFFERENTIAL (FRONT) 7E-9
11) Remove drive bevel pinion rear bearing (1) by using hydraulic
press (2) and bearing puller (3).
12) Drive out bevel pinion bearing outer races in differential carrier
by hammering metal stick (1) applied to them.
INSPECTION
D
Check companion flange for wear or damage.
D
Check bearings for wear or discoloration.
D
Check differential carrier for cracks.
D
Check drive bevel pinion and bevel gear for wear or cracks.
D
Check side gears, pinion gears and pinion shaft for wear or dam-
age.
D
Check side gear spline for wear or damage.
ADJUSTMENT AND REASSEMBLY
Judging from faulty conditions noted before disassembly and what
is found through visual check of bearing and gear tooth etc. after
disassembly, prepare replacing parts and proceed to reassembly
according to procedures as described below.
CAUTION:
D
Bevel gear and pinion must be replaced as a set when ei-
ther replacement becomes necessary.
D
When replacing taper roller bearing, replace as inner race
& outer race assembly.
DIFFERENTIAL CARRIER
For press-fitting bevel pinion bearing outer races, use special tools
as shown.
CAUTION:
Perform press-fitting carefully so as not to tilt outer race.
Special Tool
(A): 09913-75821
(B): 09924-84510-004
(C): 09913-75520