Suzuki GA413, Service Manual

Page: 390 / 1246

ON-VEHICLE SERVICE
WARNING:
Check to make sure that engine coolant temperature
is cold before removing any part of cooling system.
Also be sure to disconnect negative cable from battery
terminal before removing any part.
COOLING SYSTEM DRAINING
1) Remove radiator cap.
2) Loosen drain plug on radiator to drain coolant.
3) After draining coolant, be sure to tighten drain plug securely.
4) Fill cooling system. (Refer to Item COOLANT of MAINTE-
NANCE.)
1. Radiator
2. Radiator drain plug
COOLING WATER PIPES OR HOSES
1. Intake manifold
2. Thermostat
3. Heater core
4. Reservoir tank
5. Radiator
6. To throttle body
REMOVAL
1) Drain cooling system.
2) To remove these pipes or hoses, loosen clamp on each hose
and pull hose end off.
INSTALLATION
Install removed parts in reverse order of removal procedure, noting
the following.
Tighten each clamp securely.
Refill cooling system with proper coolant, referring to description
on COOLANT of MAINTENANCE.
Use new O-ring when installing water pipe to water pump.
6B-8 ENGINE COOLING