Suzuki GA413, Service Manual

Page: 742 / 1246

1) Turn ignition switch to “LOCK” position, remove key and put on
safety glasses.
2) Check that there is no open, short or damage in special tool (de-
ployment harness). If any faulty is found, do not use it and be
sure to use new deployment harness.
Special Tool
(A): 09932-75030
3) Short the two deployment harness leads together by fully seat-
ing one banana plug into the other.
1. Shorted
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed.
4) Remove air bag (inflator) module(s) from vehicle, referring to
SECTION 3C and 10B (if equipped with passenger air bag (in-
flator) module).
WARNING:
Always carry live air bag (inflator) module with trim
cover away from you.
When storing a live air bag (inflator) module or
when leaving a live air bag (inflator) module unat-
tended on a bench or other surface, always face the
bag and trim cover up and away from the surface.
As the live passenger air bag (inflator) module must
be placed with its bag (trim cover) facing up, place
it on the workbench with a slit or use the workbench
vise to hold it securely at its lower mounting brack-
et.
This is necessary so that a free space is provided
to allow the air bag to expand in the unlikely event
of accidental deployment.
Failure to follow procedures may result in personal in-
jury.
1. Slit on workbench
2. Workbench vise
3. Lower mounting bracket
ALWAYS CARRY AIR BAG (INFLATOR) MODULE
WITH TRIM COVER (AIR BAG OPENING) AWAY
FROM BODY.
ALWAYS PLACE AIR BAG (INFLATOR) MODULE
ON WORKBENCH WITH TRIM COVER (AIR BAG
OPENING) UP, AWAY FROM LOOSE OBJECTS.
10B-48 AIR BAG SYSTEM