Suzuki GA413, Service Manual

Page: 729 / 1246

REPAIRS AND INSPECTIONS REQUIRED AFTER AN ACCIDENT
ACCIDENT WITH DEPLOYMENT/ACTIVATION – COMPONENT REPLACEMENT
Certain air bag system components must be replaced. Those components are:
Driver air bag (inflator) module and passenger air bag (inflator) module (if equipped)
– Replace with new one.
SDM after detecting such collision as to meet deployment conditions
– Replace with new one.
CAUTION:
All air bag system components, including the electrical harness (component mounting points),
must be inspected after an accident. If any components are damaged or bent, they must be re-
placed even if air bag system activation did not occur.
Never use air bag system parts from another vehicle.
Do not attempt to service the parts below. Service of these parts is by replacement only.
– Driver air bag (inflator) module/Passenger air bag (inflator) module (if equipped)
– SDM
– Contact coil and combination switch assembly
– Air bag wire harness
Proper operation of the sensors and air bag system requires that any repairs to the vehicle struc-
ture return it to its original production configuration.
CAUTION:
After detecting one time of such collision as to meet deployment conditions, the SDM must not be
used. Refer to AIR BAG DIAGNOSTIC SYSTEM CHECK in this section when checking the SDM.
ACCIDENT WITH OR WITHOUT DEPLOYMENT/AC-
TIVATION – COMPONENT INSPECTIONS
Certain air bag and restraint system components must be in-
spected after any crash, whether the air bag deployed or not.
Those components are:
Steering column and shaft joints
– Check for length, damage and bend according to CHECKING
STEERING COLUMN FOR ACCIDENT DAMAGE in SEC-
TION 3C.
If any faulty condition is found in above checks, replace faulty
part.
Steering column bracket and capsules
– Check for damage and bent.
If any faulty condition is found in above checks, replace faulty
part.
1. Steering column
2. Steering lower shaft
AIR BAG SYSTEM 10B-35