Suzuki GA413, Service Manual

Page: 71 / 1246

6) Tighten front head bolts.
Tightening Torque
(a): 14 N·m (1.4 kg-m, 10.5 Ib-ft)
(b): 23 N·m (2.3 kg-m, 17.0 Ib-ft)
NOTE:
Be sure to use new front head bolt washer.
Tighten bolt (a) first, and next (b).
1. Front head
7) Install magnet clutch coil.
Protrusion on lower side of coil ring must match hole in com-
pressor assembly to prevent movement and correctly locate
lead wire.
8) Using special tool (C), install snap ring as shown.
Special Tool
(C): 09990-06107
9) Clamp covering portion of lead wire.
1. Snap ring
2. Clutch coil
3. Compressor
assembly
10) Install magnet clutch.
(1) Set magnet clutch squarely over clutch installation boss.
(2) Place special tool (F) onto clutch bearing.
Ensure that edge rests only on inner race of bearing.
(3) Install snap ring.
Special Tool
(F): 09991-06010
CAUTION:
Be careful not to scratch bearing seal.
11) Adjust clearance, between armature plate and magnet clutch
by putting shim on compressor shaft.
Standard clearance “a”: 0.3 – 0.6 mm (0.012 – 0.024 in.)
AIR CONDITIONING 1B-17