Suzuki GA413, Service Manual

Page: 536 / 1246

10) Install rectifier holder. Curl stator leads as shown in figure.
CAUTION:
When installing rectifier, check to confirm that stator
leads have enough clearance with cooling fan
blades.
1. Rectifier holder
2. Bolt
3. Stator lead
Tightening Torque
(a): 2.0 N
.
m (0.2 kg-m, 1.5 lb-ft)
11) Install brush holder cover to brush holder.
12) Place IC regulator together with brush holder horizontally on
rear end frame.
13) Install 5 screws until there is a clearance of approx. 1 mm (0.04
in.) between brush holder and connector.
Tightening Torque
2.0 N
.
m (0.2 kg-m, 1.5 lb-ft)
1. IC regulator
2. Brush holder
3. Rear end frame
14) Install rear end cover.
Tightening Torque
(a): 4.5 N
.
m (0.45 kg-m, 3.5 lb-ft)
15) Install insulator and tighten B terminal inner nut to specified
torque.
Tightening Torque
(b): 4.2 N
.
m (0.42 kg-m, 3.0 lb-ft)
1. Rear end cover
2. Insulator
3. B terminal inner nut
16) Make sure that rotor turns smoothly.
CHARGING SYSTEM 6H-21