Suzuki GA413, Service Manual

Page: 1099 / 1246

1. Back-up light switch
2. Back-up light switch coupler
3. Speed sensor
4. Clamp
1. Clutch cable end
2. Clutch release fork 3. Clutch cable
4. Ground cable bolt
1. Control cable end clip
2. Control cable rear washer
3. Gear shift control cable assembly 4. Gear select cable
assembly
5. Control cable bracket
1. Stiffner
MANUAL TRANSMISSION (4WD) 7A1-5
DISMOUNTING
1) Disconnect negative ( – ) cable from battery terminals and hoist
vehicle.
2) Disconnect back-up light switch lead wire at coupler.
3) Disconnect Black / Yellow lead wire and positive (+) cord from
starting motor. Remove starting motor from transmission case.
4) Disconnect coupler from speed sensor and free its harness
from transmissions.
5) Remove drain plugs to drain oil in transmission.
6) Remove transmission upper case cap and take off clutch cable
end from clutch release fork. Disconnect clutch cable assem-
bly from transmission.
7) Remove body ground cable bolt.
8) Remove control cable end clips and washers, and then discon-
nect gear shift cable and select cable from each lever.
9) Remove gear shift and select control cables from bracket.
10) Remove front and rear propeller shafts referring to “ PROPEL-
LER SHAFTS ” section.
11) With transmission supported on jack, remove stiffner.