Suzuki GA413, Service Manual

Page: 912 / 1246

9) Remove special tools from fuel delivery pipe.
10) Connect fuel feed hose to fuel delivery pipe and clamp it se-
curely.
11) With engine “OFF” and ignition switch “ON”, check for fuel
leaks.
FUEL PUMP
ON-VEHICLE INSPECTION
CAUTION:
When fuel filler cap is removed in any procedure, work
must be done in a well-ventilated area, keep away from
any open flames and without smoking.
1) Remove filler cap and turn ON ignition switch (2). Then fuel
pump operating sound should be heard from fuel filler (1) for
about 2 seconds and stop. Be sure to reinstall fuel filler cap after
checking.
If above check result is not satisfactory, advance to “Diagnostic
Flow Table B-2” in Section 6.
2) Turn OFF ignition switch and leave over 10 minutes as it is.
3) Fuel pressure should be felt at fuel feed hose (1) for 2 seconds
after ignition switch ON.
If fuel pressure is not felt, advance to “Diagnostic Flow Table
B-3” in Section 6.
1. Fuel return hose
2. Air cleaner
REMOVAL
Remove fuel tank from body according to procedure described in
Section 6C and remove fuel pump from fuel tank.
INSPECTION
Check fuel pump filter for evidence of dirt and contamination. If
present, clean and check for presence of dirt in fuel tank.
6E-20 ENGINE AND EMISSION CONTROL SYSTEM
GA413
supple