Suzuki GA413, Service Manual

Page: 658 / 1246

BACK DOOR/QUARTER WINDOW GLASS
REMOVAL
1) Disconnect rear defogger coupler.
2) As window glass is fixed by means of window weatherstrip, re-
move glass and weatherstrip together by removing end of
weatherstrip little by little while pushing the entire glass from in-
side toward outside as shown in the figure.
NOTE:
Do not apply an excessive force to glass locally.
1. Weatherstrip
2. Glass
3. Back door panel/side panel
Vehicle outside
INSTALLATION
1) Install weatherstrip to glass.
2) Pass string through outer groove of weatherstrip (groove where
panel fits in) so that weatherstrip can be installed with ease.
3) Apply soap water to outer edge of back door panel or side panel
and install glass and weatherstrip together to back door or side
panel by pulling the string little by little.
4) Connect rear defogger coupler. (if equipped)
1. Weatherstrip
2. Glass
3. Back door panel/side panel
4. String
5) Check for water leakage by running water from hose over win-
dow. If leakage is found, complete the installation of leaky point.
If water still leaks even after that, remove glass and start instal-
lation procedure all over again.
NOTE:
Do not use high pressure water.
9-22 BODY SERVICE