Suzuki GA413, Service Manual

Page: 745 / 1246

WARNING:
After deployment, the metal surfaces of the air bag
(inflator) module will be very hot. Do not touch the
metal areas of them for about 30 minutes after de-
ployment.
Do not place the deployed air bag (inflator) module
near any flammable objects.
Do not apply water, oil, etc. to deployed air bag (in-
flator) module.
If the deployed air bag (inflator) module must be
moved before it is cool, wear gloves and handle it
by using nonmetal material such as the air bag and
vinyl trim.
Failure to follow procedures may result in fire or per-
sonal injury.
12) Separate the two banana plugs on the deployment harness.
13) Connect the deployment harness to the power source (12V
vehicle battery) to immediately deploy the air bag.
14) Disconnect the deployment harness from power source (12V
vehicle battery) and short the two deployment harness leads
together by fully seating one banana plug into the other.
15) In the unlikely event that the air bag (inflator) module did not
deploy after following these procedures, proceed immediately
with Steps 20) through 23). If the air bag (inflator) module did
deploy, proceed with Steps 16) through 19).
16) Put on a pair of shop gloves to protect your hands from pos-
sible irritation and heat when handling the deployed air bag (in-
flator) module.
17) Disconnect the deployment harness from the air bag (inflator)
module as soon after deployment as possible.
NOTE:
This will prevent damage to the deployment harness due
to possible contact with the hot air bag (inflator) module.
The deployment harness are designed to be reused. They
should, however, be inspected for damage after each de-
ployment and replaced if necessary.
1. Connect one banana plug to positive terminal of pow-
er source (12V vehicle battery) and then the other to
negative terminal to immediately deploy.
2. Short to two deployment harness leads.
AIR BAG SYSTEM 10B-51