Suzuki GA413, Service Manual

Page: 35 / 1246

8) Add coolant to reservoir so that its level aligns with FULL mark.
Then, reinstall cap aligning arrow marks on reservoir and cap.
NOTE:
When installing reservoir cap, align arrow marks on reser-
voir and cap.
CAUTION:
When changing engine coolant, use mixture of 50%
water and 50% ANTIFREEZE / ANTICORROSION
COOLANT for the market where ambient temperature
falls lower than –16
_
C (3
_
F) in winter, and mixture of
70% water and 30% ANTIFREEZE / ANTICORROSION
COOLANT for the market where ambient temperature
doesn’t fall lower than –16
_
C (3
_
F).
Even in a market where no freezing temperature is an-
ticipated, mixture of 70% water and 30% AN-
TIFREEZE/ ANTICORROSION COOLANT should be
used for the purpose of corrosion protection and lu-
brication.
1. Full level mark
2. Low level mark 3. Tank cap
4. Match marks
ITEM 1-6
Exhaust Pipes and Mountings Inspection
When carrying out periodic maintenance, or the vehicle is raised
for other service, check exhaust system as follows:
D
Check rubber mountings for damage, deterioration, and out of
position.
D
Check exhaust system for leakage, loose connections, dents
and damages.
If bolts or nuts are loose, tighten them to specification.
D
Check nearby body areas for damaged, missing, or misposi-
tioned parts, open seams, holes, loose connections or other
defects which could permit exhaust fumes to seep into the ve-
hicle.
WARNING:
To avoid danger of being burned, do not touch exhaust
system when it is still hot. Any service on exhaust sys-
tem should be performed when it is cool.
0B-10 MAINTENANCE AND LUBRICATION