Suzuki GA413, Service Manual

Page: 747 / 1246

DEPLOYMENT INSIDE VEHICLE
Use this procedure when scrapping the entire vehicle including the
air bag (inflator) module(s).
CAUTION:
When vehicle itself will be used again, deploy the air bag
outside vehicle according to DEPLOYMENT OUTSIDE
VEHICLE, for deploying it inside will cause the instru-
ment panel, glove box and their vicinity to be deformed.
Failure to observe this CAUTION may require unneeded
vehicle inspection and repair.
1) Turn ignition switch to “LOCK” position, remove key and put on
safety glasses.
2) Remove all loose objects from front seats and instrument panel.
3) For driver air bag (inflator) module:
Disconnect contact coil connector (Yellow connector) located
near the base of the steering column.
For passenger air bag (inflator) module (if equipped):
Remove glove box from instrument panel and disconnect pas-
senger air bag (inflator) module connector (Yellow connector).
4) Confirm that each air bag (inflator) module is securely mounted.
For driver air bag (inflator) module
For passenger air bag (inflator) module (if
equipped)
5) Check that there is no open, short or damage in special tool (de-
ployment harness). If any faulty condition is found, do not use
it and be sure to use new deployment harness.
Special Tool
(A): 09932-75030
6) Short the two deployment harness leads together by fully seat-
ing one banana plug into the other.
7) Connect deployment harness connector to air bag (inflator)
module (driver or passenger (if equipped)) and lock connector
with lock lever.
1. Short deployment harness leads.
For driver air bag (inflator) module
WARNING:
Deployment harness shall remain shorted and not be
connected to a power source until the air bag is to be
deployed.
AIR BAG SYSTEM 10B-53