Suzuki GA413, Service Manual

Page: 1040 / 1246

3. Positive cable
MAINTENANCE AND LUBRICATION (4WD) 0B1-5
MAINTENANCE SERVICE
ENGINE
ITEM 1-1
Drive Belt Inspection and Replacement
WARNING:
All inspection and replacement are to be performed with
ENGINE NOT RUNNING.
Water pump and generator drive belt (V-rib belt)
Inspection
1) Disconnect negative cable at battery.
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If any defect exists, replace.
Check belt for tension.
Water pump and generator belt tension
“ a ” : 6 – 8 mm (0.24 – 0.32 in.) deflection under 100 N (10 kg,
22 lb) pressure
NOTE:
When replacing belt with a new one, adjust belt tension to
5
– 7 mm (0.20 – 0.27 in.).
3) If belt is too tight or too loose, adjust it to specification by displac-
ing generator position. For adjustment, tighten or loosen belt ad-
justing bolt (3) after loosening adjusting bolt (1) and pivot bolt (2).
4) Tighten adjusting bolt (1) and pivot bolt (2) to specified torque.
Tightening Torque
(a): 23 N
.
m (2.3 kg-m, 16.5 lb-ft)
(b): 50 N
.
m (5.0 kg-m, 36.5 lb-ft)
5) Connect negative cable to battery.
Replacement
Replace belt. Refer to GENERATOR (WATER PUMP) BELT in
SECTION 6H for replacement procedure.
A/ C compressor drive belt (V-belt) (if equipped)
Inspection and Replacement
1) Disconnect negative cable (1) at battery (2).
2) Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If any defect exists, replace.