Suzuki GA413, Service Manual

Page: 738 / 1246

SDM
WARNING:
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM).
Be sure to read SERVICE PRECAUTIONS in this section
before starting to work and observe every precaution
during work. Neglecting them may result in personal in-
jury or inactivation of the air bag system when neces-
sary.
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to DISABLING AIR BAG SYS-
TEM of SERVICE PRECAUTIONS in this section.
3) Remove console box by removing screws and clips.
4) Remove SDM cover.
5) Disconnect SDM connector from SDM.
6) Remove SDM (with SDM plate) as an assembly from vehicle.
NOTE:
Do not separate SDM and SDM plate.
INSPECTION
CAUTION:
Do not connect a tester whatever type it may be.
Never repair or disassemble SDM.
If SDM was dropped from a height of 90 cm (3 ft) or
more, it should be replaced.
Check SDM and SDM plate for dents, cracks or deformation.
Check SDM connector for damage, cracks or lock mechanism.
Check SDM terminal for bent, corrosion or rust.
If any faulty condition is found in above checks, replace.
INSTALLATION
For installation, reverse removal procedure, nothing following
points.
Tighten SDM bolts to specified torque.
Tightening Torque
(a): 6 N·m (0.6 kg-m, 4.5 lb-ft)
Connect SDM connector to SDM securely.
Enable air bag system. Refer to ENABLING AIR BAG SYSTEM
of SERVICE PRECAUTIONS in this section.
1. Console box
2. SDM cover
3. SDM
4. SDM bolt
5. SDM connector
6. Ground for air bag system
10B-44 AIR BAG SYSTEM