Suzuki GA413, Service Manual

Page: 365 / 1246

8) Remove under cover and its stay.
9) Disconnect following hoses:
Canister purge hose from EVAP canister purge valve
Radiator outlet hose from water floor pipe
Brake booster hose from intake manifold
Heater inlet and outlet hose from water floor pipe
Fuel feed hose and return hose from each pipe
Radiator inlet hose, brake booster hose and reservoir hose
from water floor pipe
NOTE:
ALPHABET in the figure shows where each hose is con-
nected.
10) Disconnect accelerator cable from throttle body and each
clamp.
11) Remove generator.
12) With hose connected, detach A / C compressor and bracket
from cylinder block if equipped.
NOTE:
Suspend removed compressor at a place where no dam-
age will be caused during removal and installation of en-
gine assembly.
13) Hoist vehicle.
14) Drain engine oil if necessary.
15) Remove exhaust pipe bolts.
16) Disconnect clutch cable from clutch release arm and transmis-
sion case (engine and transmission stiffener).
Remove propeller shaft.
17) Disconnect shift and select cable from transmission case.
ENGINE MECHANICAL 6A-59